NOISY PIPES

WARNING: Should you wish to perform your own plumbing maintenance using the information we provide on this website, please be advised that Old School Plumbing cannot be held responsible for any work not performed by our  own licensed master plumber.  Failure to contract any plumbing work to a licensed master plumber could result in serious bodily injury or death.

Noisy Pipes
Banging
Squeaking
Water Hammer

 

Noisy Pipes

Pipe noises range from loud hammering sounds to high-pitched squeaks. The causes may be loose pipes, water logged air chambers, or water pressure that's too high. Anchoring exposed pipes is a simple solution; other remedies such as anchoring pipes concealed inside walls, floors or ceilings, may call for a professional.

Banging

Pipes are usually anchored with pipe straps every 6 to 8 feet for horizontal runs, 8 to 10 feet for vertical.

  • If your pipes bang when you turn on the water, you may need to add straps, cushion the pipes with a rubber blanket, or both.
  • When you anchor a pipe-especially a plastic one-leave room for expansion.
  • Don't use galvanized straps on copper pipes.

Squeaking

Only hot water pipes squeak. As the pipe expands, it moves in its strap, and friction causes the squeak.

  • Solution: Cushion it as you would a banging pipe.

Water Hammer

This noise occurs when you turn off the water at a faucet or an appliance quickly. The water flowing through the pipes slams to a stop, causing a hammering noise.

Check for:

  • Loose Pipes

Remedy:

  • Anchor the pipes.

Check for:

  • Faulty air chambers. These lengths of pipe, installed behind fixtures and appliances, hold air that cushions the shock when flowing water is shut off. They can get filled with water and lose their effectiveness.

Remedy:

  • To restore air to the chambers, turn off the water at the main shutoff valve. Open all the faucets to drain the system. Close the faucets and turn the water on again. The air chambers should fill with air.

Check for:

  • Water pressure that's above 80 psi (pounds per square inch).

Remedy:

  • To lower the pressure, install a pressure-reducing valve (you can call in a plumber to do the work if this is a job you don't want to do yourself).